Tumo-Int 3000W 5 Blades Wind Turbine, Руководство пользователя

Страница: 19 / 22

18
situations and get rid of the troubles. In the event of burning of controller, please
contact supplier to solve problems.
9.7 Solar Output Voltage Too Low or No Output in Wind and Solar hybrid System
Check whether solar panel lead is short circuit, circuit break, open circuit or not.
9.8 Light Source Is Not On in Wind and Solar hybrid System
This situation is mainly cause by:
① Light source is damaged and need to be replaced;
②
Battery is under voltage, controller does not supply power, which is system normal
protection;
③ Controller is burned out and needs to be replaced;
④ The mode setting on the controller is not correct and needs to be reset according to
controller manual.
9.9 Wind Turbine Does Not Charge Battery
This situation is mainly caused by:
①
Wind speed is too small to reach cut in state, output DC voltage of wind turbine is
lower than battery voltage;
② Type of battery is not matched with controller, battery should be replaced (commonly
use lead acid battery);
③
Burning of controller results in not charging battery, controller should be replaced;
④
Battery is fully charged, controller is over-voltage protection.
9.10 On-grid inverter faults and trouble shooting refers to inverter fault codes and
solutions.
Ten --- Packing, Transportation and Storage
10.1 Tumo-Int wind turbine components are packaged separately in accordance with
national standard packaging requirements.
10.2 Tumo-Int wind turbine meets transportation requirements of all components.
10.3 Tumo-Int wind turbine meets storage requirements of all components.