9
Figure 2. The working depth is adjusted by turning the square disc shafts. The
figure shows the transport position.
The maximum working depth is set by first limiting the stroke length of the working
depth adjustment cylinder. See Figure 3.
Figure 3. The max. working depth is set by limiting the cylinder stroke length.
First raise the discs to the upper position, i.e. transport position. Determine the required
maximum working depth for the field plot and compare this value with the values marked
on the label shown in Figure 3. Select the closed value and insert the limit pin into the
corresponding hole.
The cultivator must be lowered on the tractor’s lifter and the tractor
engine turned off before performing the basic working depth adjustment.
The disc working depth adjustment is
made by rotating the square disc shafts
using the hydraulic cylinder.
The maximum working depth
corresponding to each hole
is shown on the working
depth label.
Limit pin
Depth adjustment
