Tugicom TX190, Руководство пользователя

Страница: 8 / 8

After the on-air delay, if the TX190 is locked the RF output will be enabled and you will be ON-AIR.
In order to enable or disable RDS and change the Stereo\mono audio type, both Up and Down buttons should be pressed together and
held while power up the TX190.
The TX190 will enter RDS setup mode and the display will show:
Using Up button, enable or disable the RDS, when done, press Down button to save and exit.
In case of failure or error in the VCO or PLL lock process the TX190 will notice you that there is problem so you can reset the unit.
Using the RDS
Install the RDS sftware that you have downloaded from our site.
Connect the RDS cable to the DATA connector on the TX190 and the other side to the USB port on the PC.
IMPORTANT :
Thank you for purchasing one of our products.
Tugicom RF Design.
Come visit our website for updates and new products: www.tugicom.com
Please check the rules in your country before operating radio equipment.
101.5 mhZ fm
tx190 <on air>
mode : stereo
up - mono dwn - save
rds : on
up - - save
We are using RDS made by “pira.cz” (special edition of MRDS192)
* In our special rds edition, we cancel the “read” function!!!!
The software is user friendly, if any problem occurs please refer to the help section