Tufner T918M, Руководство пользователя, Страница: 10 / 21

8
OPERATING INSTRUCTIONS
Power On
● Turn on the power by pressing the power button for 3 sec-
onds. Once on, the scale will flash the voltage and then begin
to auto-check and count down from 0-9
sequentially before entering the weighing mode
Note: Anything on the scale before powering on will auto-
matically be tared out
Zeroing
● The zero function is used only when the scale is empty and is
not at gross zero due to material build up
● Pressing the ZERO key will reset your scale to 0
● Depending on what your manual zero range parameter is set
to, you can zero out any number within your set selection,
after that you will receive an error and will need to tare out
the weight
Tare Function
● The Tare function is used when you only wish to see the cur-
rent change in weight, not the entire amount of weight that
is on the scale
● When the indicator is in gross mode (gross light is shown)
pressing the ZERO key will Tare the current weight on the
scale and enter the net mode (net light shown)
● For example, if you are using a pallet add the pallet to the
scale, press tare and the display will show the tare symbol
and reset back to 0
● Add your product to the scale to weigh without the weight of
the pallet
● To exit Tare mode press the ZERO key again to enter gross
mode and you will see the total weight of the pallet and the
product
Note: If you remove the pallet the scale will show the minus weight
of the pallet