8000 REPEL
Digital Weight Indicator User Manual
11
the sample size. Repeat Step #4 with the new sample size.
NOTE:
If the indicator continues to display “Lo” even after sampling 1
00 pieces, the
unit weight of the items you wish to count is too light for your scale to process ac-
curately.
5. To exit the piece count mode, press the UNITS key.
NOTE:
The APW will NOT remain in scale memory when you exit piece counting
mode.
4.4 Peak Hold Mode
IMPORTANT NOTE:
The peak hold function cannot be used in commercial (NTEP) appli-
cations.
This mode of operation is enabled by setting F30 to “5” in the Setup Menu and
F35 to
“3” in the User Menu (see separate installer’s guide for more information).
This mode
is used to indicate and hold the peak weight recorded during a specific process. The
most common application is testing the breaking point of a part or assembly. The
8000
REPEL
records both positive and negative peak weights.
1. Push the UNITS key to active peak hold mode; the
“P” annunciator turns ON.
2. Apply force to the piece
–
the display indicates and holds the peak force ap-
plied.
3. To toggle between positive and negative peak weights, use the NET/GROSS
key.
4. To reset both peak values to zero, press the ZERO key.
5. To exit peak hold mode, press the UNITS key again;
the “P” annunciator turns
OFF.
4.5 Accumulation (Totaling)
This mode of operation is enabled by setting F30 to “1” in the Setup
Menu
(see sepa-
rate installer’s guide for more information).
The mode allows you to add weighments
together to obtain a total weight. When a tare weight is active, the net weight is added
automatically.
1. Load the system with the weight that is to be added.
2. Press the PRINT key to add the current load to the weight accumulator.
3.
The display briefly shows the message “ADDED” and then automatically returns
to the weighing mode.
Содержание 8000 REPEL
Страница 19: ......
