4.1 BASIC TOOL REQUIRED
Drill, 4mm drill bit
4.2 MULTI-FIT SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
- 2 x grub screws
-
2 x solid bar end piece
- 1 x Tonneau bar sheath
4.3 FITTING MULTI-FIT BAR
1.
Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket
holders with the holes facing to the ground (so the grub screws don’t rub against the tonneau),
as shown above and then with a white pencil make a mark through the small holes of the
hollow bar onto the solid ends. This is where you will drill a hole to the depth of about 1-2mm
(do not go any further)
2.
Join the pieces back together and screw grub screws through the hollow bar into the holes that
you drilled.
Make sure you do not over tighten the grub screws
. Then place the
tonneau sheath over the bar to stop the bar wearing against the tonneau. Refit the bar. You
may kink the bar in the middle to give it some extra height to assist with water runoff.
Warning if you do not fit the tonneau sheath over the bar, the tonneau cover will quickly wear
through which is not covered by warranty.
5.
WARRANTY AND FEEDBACK
Please register your warranty details online at:
QR Code:
Website Link
:
https://www.tto.com.au/en-au/warranty.html
Please complete our 2 minute feedback section as we strive to constantly
improve for our customers
.
Your Tuff Tonneau is now ready for work.
