6. Loosen and remove the air fitting from the top of the
strut.
7. Move to the upper strut mounting hardware and remove
the 3 nuts. Carefully lower the strut assembly out of the
vehicle.
8. Locate a new front strut spacer and install it on the top of
the OE strut. Secure the new spacer to the strut using the
OE hardware.
Torque to 45 ft lbs
*Photo above is shown with non-air ride strut. *
9. Locate (3) 3/8” nylock nuts, and (3) 5/16” USS flat
washers from hardware bag D2PNB. Working on the driver
side, install the strut back into the vehicle and start the new
hardware. Only hand tighten at this time.
10. Raise the lower control arm up so that the lower strut
mounting bolt can be re-installed but not tightened yet.
11. Re-install the lower control arm mounting/adjusting
bolts and do not tighten yet.
