Recommended tool selection:
Torque wrench
Standard socket set
Standard wrench set
Metric socket set
Metric wrench set
Tape Measure
With the vehicle sitting on a level surface and under
its own weight, record ride height measurements by
measuring from the center of the wheel hub up to the
leading edge of the front fender. Recorde measure-
ments below.
Pre Installation Measurements:
Driver side front : ____________________________
Passenger side front : ________________________
Post Installation Measurements:
Driver side front : ____________________________
Passenger side front : ________________________
**Photos may vary slightly depending on the
year of the vehicle**
1. To begin installation, park on level ground and put
the vehicle in
NORMAL MODE
. Turn on
JACK MODE;
Settings, Suspensions, Jack Mode, then turn truck off.
block the rear tires of the vehicle so that the vehicle is
stable and can’t roll backwards. Safely lift the front of the
vehicle and support both the driver and passenger side
frame rail with jack stands. Remove the tires and wheels
from both sides.
2. Remove the lower swaybar endlink mounting hardware
at the lower control arm and save the hardware.
3. Remove the lower strut mounting hardware at the lower
control arm and save the hardware.
4. Carefully remove the lower control arm mounting/adjust-
ing bolts so that the lower control arm can be dropped out
of its frame pockets.
Special Note: once these bolts are
removed, the lower control arm and front suspension
will be able to drop out quite a bit, be careful not to
over extend any front brakelines or ABS wires.
