BUILD INSTRUCTIONS
Tuff Birds
Super Tough Wings & Planes
Test fit the panels, and use a bead of CA to glue
the panels together. Make sure they are aligned.
Leave aside to dry. When completely set, add a
bead hot glue and wipe it off to secure the entire
joint.
Use the Battery tray as a guide to make space for
the cut out of the battery area.
Cut only as deep as required for the battery. Leave
at least 10MM of foam at the bottom of the wing.
The Battery bay is usually required to be cut as far
forward as possible. The battery location may
need to be adjusted later to get the plane
balanced properly.
5. Cut Battery Location
6. Join Wing Panels
7. Install Spars
If Laminating , then laminate the elevons in at
least 2-3 layers to add rigidity. Laminate the
bottom wing first and then the top side. Hinge
using Laminate or Clear packing tape.
If not laminating, then use our EPP Hot Glue
Hinge method to install the elevons.
8. Laminate Panels OR Hot Glue Hinge
The 5MM Spar has to be installed on the panels
Use the knife to make a shallow cut, and use the
end of the spar to make enough space for a tight
fit Use CA to glue the spar. The Main Spar can be
glued 130Mm from the tip of the nose. This is
the CG location.
5MM Spar
130MM
3
Micro BEE
600MM Flying Wing
Ver 1.0 12 May 2018
