Tubeline Boss I, Руководство оператора

Страница: 4 / 28

4
INTRODUCTION
Thank you for purchasing your new Boss I square bale processor. Your Boss I was designed to
load and shred all types of forage in large square bales up to 1500 pounds (680 kg). Maximum
length of bales is 84” (213 cm) X 36” (91 cm) X 36” (91 cm)
The Boss I square bale processor has multiple uses:
Laying windrows in open fields.
Filling feed bunks
– fence line, circular, etc.
Spreading forage for livestock bedding.
Spreading mulch over perennial plants such as strawberries and mushrooms.
The Boss I was carefully designed and manufactured to give you many years of dependable
service. You or any other person, who will be assembling, operating, maintaining or working with
this product, are required to read and completely understand the information and instructions
contained in this manual. If anyone does not fully understand every part of this manual, please
obtain further assistance by contacting the dealer from which this product was purchased or by
contacting Tube·Line at the telephone number or address listed on the previous page of this
manual. Keep this manual available for reference whenever this product is being handled or
used. Provide this manual to any new owners and/or operators.
GENERAL INFORMATION
The purpose of this manual is to assist you in safely assembling, mounting, operating and
maintaining your Boss I. Read this manual carefully to obtain valuable information and
instructions that will help you achieve safe and dependable service. The illustrations and data
used in this manual were current at the time of printing, but due to possible engineering and/or
production changes, this product may vary slightly in detail. Tube·Line reserves the right to
redesign and/or change components as necessary without notification.
Throughout this manual, references may be made to:
Power Unit The engine-driven machine to which this product must be attached.
Right, Left,
Front, Rear
Directions which are determined in relation to the operator of the equipment
when seated in the normal operating position.
IMPORTANT Precautions that must be followed to prevent damage to equipment.
NOTICE Precautions that must be followed to prevent substandard performance.
SERIAL NUMBER LOCATION
Always refer to the model and serial number when ordering parts or requesting
information from your dealer. The serial number plate is located on upper left
front corner of the tub of your Boss I. Refer to diagram on page 6.