Step 6
– Solder these wires to the solder terminals of the
speaker; the white wire to the “+” terminal and the black wire to
the “-” terminal (photo 4.3e).
Proceed to 4.4
Installing the Shielding Tape
Step 1
– Place the removed back panel with the tweed side toward
the desk and the wood side facing up.
Step 2
– Cut the 30” aluminum shielding tape strip into three equal
lengths of 10”
Step 3
– Remove the backing from the first of the three shielding tape strips.
Step 4
– Apply the aluminum tape to the back of the
panel. Leave 1/8
th
of an inch space at the top of the
panel and centered the strip between the two panel
edges (photo 4.4a).
Step 5
– Remove the backing from the second
shielding tape strip and apply the tape to the back of
the panel similar to the first strip. Place it just below the
first strip, over lapping by 1/8
th
of an inch and centered
on the panel.
Step 6
– Remove the backing from the final shielding
tape strip and apply the tape to the back of the panel
similar to the previous two strips. Align the edge of the
tape along the bottom edge of the panel, offset by 1/8
th
of an inch from the bottom edge of the panel and overlapping the second strip (photo 4.4b).
Proceed to chapter 5
TubeDepot.com 7
4.4
photo 4.3e
Once the backing is removed from the aluminum tape, the tape will have a tendency to curl.
Be sure to keep the tape straight to avoid having the tape stick permanently to itself.
CAUTION
photo 4.4a
photo 4.4b
