Wiring Chassis Ground to Signal Buss Ground
Step 1
– Bend the violet wire attached to terminal T25 under the
board and past turret T24 on the buss ground side of the board.
Temporarily feed it around the buss ground wire just to hold it in
place (photo 7.1a).
Step 2
– Locate the 18AWG black ground wire attached to the
solder terminal nearest the normal channel input jacks mounted
under the standoff (photo 7.1b).
Step 3
– This is the last wire to be connected to this solder
terminal. Therefore any wires previously tacked in place can be
fully soldered to this terminal.
Step 4
– Solder the wire from the solder terminal to the ground buss on the board nearest
turret T6 (photo 7.2a).
Step 5
– Secure the board to the standoffs with the four #6 -32 – 1/4” screws.
Wiring Input Jack Grounds to the Signal Buss Ground
Step 1
– With the turret board installed on the stand offs, locate the
18AWG black wire coming from the two input jack assemblies.
Step 2
– Strip and tin this wire and solder to the signal buss ground
nearest the point where the chassis ground wire is also soldered.
Wiring Volume Control Grounds to the Signal Buss
Ground
Step 1
– Locate the 20AWG black wire attached to the normal channel
volume control (photo 7.5a).
Step 2
– Strip and tin this wire and solder it to the signal buss ground
nearest turret T6 (photo 7.2a).
Step 3
– Locate the 20AWG black wire attached to the tremolo channel
volume control (photo 7.6a).
Step 4
– Strip and tin this wire and solder it to the signal buss ground
nearest turret T30 (photo 7.3a)
Wiring Tremolo Control Grounds to the Signal Buss Ground
7.1
photo 7.1a
NOTE
Remove the standoffs from the board and remount the standoffs to the chassis if they
were previously used to support the turret board while soldering components and / or
wiring.
Board Assembly
7
Chassis and Turret
photo 7.1b
7.2
7.3
7.4
NOTE
All wires are slightly longer than needed. Therefore, prior to soldering the wires to the
terminals, test the length of the wires to the terminals and cut to length as needed.
TubeDepot.com 41
photo 7.2a
photo 7.3a
Содержание 18 WATT
Страница 70: ...66 TubeDepot com D How to Swage Fit Turrets...
Страница 71: ...TubeDepot com 67 How to Press Fit Turrets E...
