Tube Technology Fusion HB70, Руководство пользователя

Страница: 7 / 13

This chapter contains information on;
Controls & Remote Functions
Diagram 2
Front Panel
Operating your System - 7
Operating
your System
Switch on the Fusion HB70 by pressing the rocker MASTER SWITCH(9) diagram 1 located
on the rear panel, to ON . The amplifier will display SLEEP in the display. Pressing the Power
Button
will commence the power-up routine. The amplifier will remain in a MUTE
state, for 30 seconds until the internal vacuum tubes have reached operating temperature. The
Display will show WARM-UP followed by a count-down. Pressing this button again will
place the amplifier in Stand-By mode, using minimum power, the ST/BY led
is illuminated
Select the desired source to be played by pressing either the remote control handset or
corresponding button on the front panel, the input selected illuminated in the display
Switching
ON & OFF
Controls &
Remote
Function s
Numbers in the circles relate to the Front Panel - Diagram 2
Letters in the ellipses relate to the Remote Control Handset - Diagram 3
Turn the Rotary Encoder on the Front Panel or press the
button on the remote to increase Volume, the volume setting is
illuminated on the display
A Clockwise Turn on the control knob
increases the volume and an anti-clockwise turn decreases the volume.
If the knob is turned rapidly to a desired volume setting, a short delay
occurs before the required volume level is set.
The brightness level of the display can be set by pushing the control
knob in and turning it clockwise for increased brightness and
anti-clockwise for decreased brightness.
IT IS RECOMMENDED TO ALWAYS PLACE THE AMPLIFIER IN ST/BY / SLEEP
BEFORE SWITCHING OFF AT THE REAR.