Sensory Light Products
Important Information
Please read all instructions carefully before use.
Please retain all instructions for future reference.
WARNING:
CHOKING HAZARD - Small parts. Not for children under 3 yrs.
Fully charge the product before first use,
Only use the recommended or equivalent type batteries.
Do not short-circuit the battery terminals.
Always dispose of old batteries safely.
Rechargeable batteries are only to be charged by an adult.
Manually examine for damage the plug enclosure and other parts. In the event of any
Damage, the product and charger must not be used until the damage has been repaired.
Non-rechargeable batteries are not to be recharged.
Different types of batteries or new and used batteries are not to be mixed.
Batteries are to be inserted with correct polarity.
Exhausted batteries are to be removed from the toy.
Know your sensory products
Charging
Before first use please fully charge the product. This sensory product is supplied with a multi-region power supply. To
change the plug module simply
Release the plug module using the button and select the correct module for your country. Make sure that the module
clicks securely into position. Connect the DC jack and the product will light up red to show that it is charging. When
charging is complete the colour will change to Blue. This may take up to 8 hours. When fully charged the product will work
for around 8 hours (Depending on colour and mode selected).
The product must not be stored with the battery discharged as this can lead to premature battery failure. Always charge
the product before long term storage and switch it off using the button on the base (do not use the remote control as
this leaves the product in standby mode). Press and hold the button for about 10 seconds and the product will switch off.
Recharge at least every 6 months to keep the battery in good condition. To extend the battery life it is better to charge the
products before the battery is exhausted.
Using Your Sensory product
The lighting function is controlled by a remote control. First remove the plastic insulating tab by pulling the clear plastic
tab out of the battery compartment. Press and hold the button underneath the product until it switches on (or switch on
using the rocker switch on the larger products). You can now use the remote control to select from 16 fixed colours and 4
different colour changing modes. There are also two buttons to control the brightness.
The colour can also be adjusted by briefly pushing the button under the product. Each short press will change to the next
colour.
Technical data:
Charger output:
5VDC 1000 mA
Battery type:
Lithium ion battery 3.7V (Non- replaceable)
Remote control:
3V CR2025 Lithium battery (supplied). Effective range approximately 4m
16 colours
4 colour changing
modes
Code Description Unit size Weight(kg)
Lion battery
IP rating
EY07243 Giant Light Up Tube 31×182 9.00
3600mAh
IP44
SD12579 Light Up Floor Panel 60×60×1 4.50
2200mAh
IP44
EY07231 Light Table
80×56 5.00
4400mAh
IP44
SD12576 Mood Ball (40cm)
40
1.20
22 00mAh
IP67
SD12578 Pebble Lamp
42×29 1.50
2200mAh
IP67
EY07230 Light Up Cube
40×40×4 4.00
4400mAh
IP67
EY10437 Glow Lamp
16x25
0.8kg
2000mAh
IP23
DC Jack socket
Remote control
On/Off switch
