TTMC BS-315G, Руководство по эксплуатации

Страница: 8 / 18

7
Make sure that the power supply voltage corresponds to the voltage on the motor
plate. Connect the cable to the power supply line observing the color codes of the
individual wires, pay particular attention to the earth wire. Connect the machine, make
sure that the rotation of circular blade is in the direction shown by the arrow on the
guard.
5.5 Cutting coolant
For the cooling of the circular blade
，
fill the tank with emulsible oil obtained from a
mixture of water and AGIP ULEX 260 EP oil with a percentage of 5-7%
6. Machine start up and operation
6.1 Operation
Checks to carry out before each cut
A Tension the saw blade by rotating #64 Trifurcate handle to the end of stroke
(mechanic stop). Remember at the end of the operation to loosen the hand wheel
to avoid the slackening of the band.
B Check that the hand indicates the required cutting angle (vice scale).
C Make sure that the bow and the vice are locked by means of #54 lock handle
D With the motor off, lower the bow and check that at the end of stroke, the band
does not touch the counter-vice.
E Make sure that the piece to be cut is properly secured in the vice.
F Make sure that the cooling liquid is circulating in the machine.
It is strictly forbidden to use the machine without cutting fluid
G When starting the motor, make sure that the band rotates in the direction of the
arrow
H To obtain maximum cutting accuracy
，
the unit must be located the nearest
possible to the work piece. Clamp the work piece with the vice. Release #86 blade
guide arm with clamping lever and move it
near the vice jaw so that it doesn’t
touch it during the cutting operation, then secure it again. When carrying out this
operation, make sure that the blade guide does not come out of the bow guard
leaving a part of the blade exposed.
6.2 Cutting operation
A. Before cutting, check that the inclination is the one required. In order to correct or
change the inclination, place #54 Lock handle in position you expect and after
correction, move it back to the lock position .
B. Manual operation: Clamp the material to be cut with #2 Handle bar after having
positioned the clamp near the piece to be cut. Press main switch to
“ON” position,