5) Press
E/VFO
when done. [L2] is
displayed.
6) Enter the Second frequency using
the keypad or the Control knob.
7) Press
SCAN SRC.
The Limited
Search will begin, searching
upwards from the first frequency
to the second in a continuous
cycle.
8) To stop the Search, press the
SCAN SRC
key again.
•
To change the Search direction rotate the Control knob
clockwise or counter clockwise
•
The receiver will stay on an active channel according to the
Scan Timer settings in the VFO Menu. If the Scan Timer is
set to ‘5 seconds’, the receiver will continue Searching after
5 seconds even if the channel is still busy. If the Scan Timer
is set to ‘Busy’, the receiver will remain on the busy
frequency for as long as it stays busy, then resume
searching when the signal disappears.
5
7 8
5
6
or
5
6
NOTE:
The Limit Search always Searches upwards in Frequency.
If the first frequency is lower than the second it will search between
the two frequencies. If the first frequency is higher then the second
it will search outside the two frequencies.
E
N
G
L
IS
H
26
TSC-3000R
