TTI Ryobi EAS10A15, Руководство пользователя

Страница: 9 / 304

8
English
GB
FR DE ES IT NL PT DK SE FI NO RU PL CZ HU RO LV LT EE HR SI SK GR TR
label.
6. Tilt tank to drain moisture from tank into a suitable
container.
NOTE: Condensate is a polluting material and should
be disposed of in compliance with local regulations.
7. If drain valve is clogged, release all air pressure,
remove and clean valve, then reinstall.
WARNING
Unplug the air station and release all air from the tank before
servicing. Failure to depressurize tank before attempting to
remove valve can cause serious personal injury.
8. Rotate drain valve clockwise until tightly closed.
CHECKING THE SAFETY VALVE
See gure 11.
DANGER
Do not attempt to tamper with the safety valve. Anything
loosened from this device could y up and hit you.
Failure to heed this could result in death or serious
personal injury.
The safety valve will automatically release air if the air tank
pressure exceeds the preset maximum. The valve should
be checked before each day of use by pulling the ring by
hand.
1. Turn the air station on and allow the tank to ll. The
station will shut off when the pressure reaches the
preset maximum.
2. Turn the air station off.
3. Pull the ring on the safety valve to release air for three
to ve seconds to allow pressurized air to escape.
Release the ring. The safety release valve must
reset and hold pressure before all compressed air is
exhausted from the tank/pressure vessel.
4. Any continued loss of air after performing the above
steps indicates a problem with the safety valve.
Discontinue use and seek service before continued
use of the air station.
WARNING
If air leaks after the ring has been released or if the
valve is stuck and cannot be actuated by the ring, do
not use the air station until the safety valve has been
replaced. Use of the air station in this condition could
result in serious personal injury.
WARNING
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING
Always wear eye protection during maintenance. If
operation is dusty, also wear a dust mask.
WARNING
Always release all pressure, disconnect from power
supply, and allow unit to cool to the touch before
cleaning or making repairs on the air station.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Any continued loss of air after performing the above steps
indicates a problem with the safety valve. Discontinue use
and seek service before continued use of the air station. If
air leaks after the ring has been released or if the valve is
stuck and cannot be actuated by the ring, do not use the
air station until the safety valve has been replaced. Use
of the air station in this condition could result in serious
personal injury.
WARNING
Do not at any time let brake uids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury. Electric tools used on
berglass material,
wallboard, spackling compounds, or plaster are subject
to accelerated wear and possible premature failure
because the berglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc.
Consequently, we do not recommend using this
product for extended work on these types of materials.
However, if you do work with any of these materials,
it is extremely important to clean the product using
compressed air.
LUBRICATION
All of the bearings in this product are lubricated with a
suf cient amount of high grade lubricant for the life of