5
OPERATING MANUAL
•
Refrain from applying voltage over DC1000V/AC750V between the clamp meter terminals
and ground to guard against electric shock and clamp meter damage.
•
Be careful in measuring RMS voltage higher than DC or AC 30V, such voltage poses a shock
hazard.
•
Do not measure current in circuits carrying more than 600A with the meter jaw.
•
Do not measure voltage or current higher than the allowable input value.
•
Disconnect circuit power and discharge all high-voltage capacitors before you measure
resistance, continuity, or capacitance.
•
Do not modify the internal wiring in the meter to guard against damage to the meter and
danger.
•
Do not store or use clamp meter in an explosive or flammable environment, high
temperature, high humidity or strong electromagnetic field.
•
Comply with local and national safety regulations and requirements. Use personal
protective equipment such as approved rubber gloves, face protection, and flame-
resistant clothing to prevent shock and arc blast injury where hazardous live conductors
are exposed.
•
Clean the clamp meter case with soft cloth and neutral detergent. To prevent causing
corrosion to the case, or damage to the instrument do not use abrasives or solvents.
Make sure all water is removed before use.
ELECTRICAL SYMBOLS
Double insulation
Diode measurement
Grounding
AC or DC (alternating current or direct current)
Warning
High voltage hazard
AC (alternating current)
Continuity measurement
DC (direct current)
This symbol signifies product complies with
Australian requirements
Capacitance
