Tsubaki SHOCK RELAY TSB2CT Series, Инструкция по эксплуатации

Страница: 5 / 12

4
4. Specifications
Series TSB SA
Type Range
05 0.5 - 5A
10 1 – 10A
30 3 – 30A
Current Setting
*
1
60 5 – 60A
Starting Trip Delay Start Time 0.2 - 10s Time Setting
*
1
Trip Time Shock Time 0.2 - 5s
Accuracy Current ±10
％
(full scale)
Control Power Supply 100
～
240VAC, 50/60Hz
*
2
Rated Voltage 600VAC, 50/60Hz
Current Sensing 2 Integral Current Transformer
Mode 1-SPDT(1-C)
Rating 3A / 250VAC, Resistive
Minimum applicable load
*
3
DC10V, 10mA
Output Relay
Status Normally De-Energized
Mechanical 10,000,000 Operations Expected Output
Relay Life
Electrical 100,000 Operations
Display Monitor(MON,green), Over Current(OC,red)
Reset Auto Reset after 1s
Operating -20 - +60
℃
(-4 - +158 F) Temperature
Storage -30 - +70
℃
(-22 - +176 F)
Ambient Environment
Humidity 45 - 85
％
RH without Condensation
Insulation Between casing and circuit Over 10M
Ω
with 500 VDC Megger
Between casing and circuit AC 2000V, 5mA, 60Hz, 1min
Between contacts AC 1000V, 5mA, 60Hz, 1min
Dielectric Strength
Between circuits AC 2000V, 5mA, 60Hz, 1min
115VAC 2.70 VA(0.35W) Power Consumption
230VAC 11.00 VA(1.2W)
Case
Upper:PA6, Bottom:PA66
Material
Terminal cover PA6
Mounting 35mm DIN rail or Panel
Dimension(WxHxD /Including Integral CT Windows) 54x60x65mm
Weight Less than 200g (0.445LBS) without External CT
*1 Current and time setting ranges can be set within the warranty range, but not the upper or lower
level of setting volume.
*2 When Shock Relay Is used with Inverter, the output frequency of Inverter should be from 30Hz
to 60Hz.
*3 When directly inputting output relay contact into the programmable controller (PLC), be aware
that a minute electric current can cause contact failure
.
As for the input to PLC, it is commended
to drive the relay coil for minute current by relay signal of Shock Relay at first, then input this
relay contact to PLC.