Safety
2.
Follow the directions below for lube oil amount and lubrication method.
（
Note
）
1) Ensure that the proper amount of oil has been filled.
2) Replenish oil after 100 hours of operation or every two weeks, whichever is sooner. Once every
three months, drain old oil and wash out the inside, then replace it with new oil. Locate the plug
hole at the bottom and drain old oil.
3) When lubricating or washing the Cam Clutch, do not allow any foreign matter to enter the inner
portion of the Cam Clutch as this may cause it to function incorrectly
WARNING
Death or serious injury may result from misusing the product without following the instructions.
CAUTION
Minor or moderate injury, as well as damage to the product may result from misusing the product
without following the instructions.
Notice that although categorized under “CAUTION”, subjects discussed may lead to serious results depending on the situation.
WARNING
Make sure turning forces are not applied to Cam Clutch or turning shaft of the equipment when conducting inspection or maintenance.
Pay special attention to the back stopping application to prevent accidents.
Frequent starting and stopping will apply excessive force on the mounting. Verify mounting strength.
Inaccurate installation and mounting, various load conditions, wear and tear of parts, and life expectancy can all affect the performance of a
Cam Clutch. Inspect and maintain periodically and install a safety devise on your equipment.
Comply with Ordinance on Labor Safety and Hygiene 2-1-1 general standards.
CAUTION
To ensure safety and optimal performance, carefully read this instruction manual in its entirety.
Confirm rotational direction prior to installing.
1) Remove two of the plugs out of three to four plugs
on the outer race of the Cam Clutch
2)
Place the plugs on their face at the same height.
3) Lubricate from one
of the plug hole at upper
portion, and continue until oil comes out from the
other plug hole. then, make sure to tighten the
plugs to prevent oil leakage
