Tsubaki LINIPOWER, Инструкция по эксплуатации, Страница: 19 / 37

16
∎
Potentiometer (Option code: P)
1. Potentiometer is set at half of the resistance
(500 ohm) at the middle of the stroke, unless
otherwise specified.
2. Never rotate the screw or nut during
transportation or installation, otherwise the
relation between the stroke and resistance
can get out of control. When the resistance
is incorrect, reset 500 ohm at the middle of
stroke.
Potentiometer output the stroke of the Linipower
Jack as the change of the value of resistance.
※
In case of the special specification, confirm
the final drawing because model number or
specification might be different.
■
Rotary encoder (Option code: R)
※
Use with an equipment like sequencer or program controller, which controls the stroke as a digital signal.
1. Standard type has built-in incremental type encoder
2. It is possible to set an accurate home position of the machine in combination with a limit switch because
home position output is read out every 600 pulses.
3. Because the output is open collector type, output signal can be obtained when connected to a pull up
resistor.
Output voltage for signal 1 and 2: “H” is “(supply voltage - 1)V or more”
“L” is “1V or less”.
Reference for pull up resistance:
DC 5V: 220 Ω / DC12V: 470 Ω / DC24V:1k Ω
4. Rotary encoder is a precision instrument. Never apply vibration or shock.
5. Use shield wire for wiring of rotary encoder.
Potentiometer
Specification
Terminal #
Type CP-30
Maker Sakae
Total
resistance
1.0k Ω
Power rating 0.75W
Insulation
rating
AC1000V
(1min )
Effective
electrical
angle
355°
Effective
angle of
rotation
360°(infinite)
Encoder Specification
Type TS5305N251
Maker Tamagawa Seiki Co., Ltd
Output pulse 600C / T
Output form Open collector
Output wave
90° phase difference, 2 phase square
wave,
－
home position signal
Output voltage
H
－
L 1V or less
Power supply DC5V to 24V 100mA or less
Signal 1 Signal 2 Signal Z +5 to +24V 0V Case
（９） （１０） （１１） （１２） （１３） （１４）
※
Rotary encoder is set to output 300 pulses per
rotation of input shaft of Linipower Jack.
※
In case of the special specification, confirm the
final drawing because model number or
specification might be different.
( ) represents
the terminal number.
Output connection
P1
(1)
P3
(3)
P2
(2)
( ) indicates to terminal
( ) indicates terminal No.
★
★