TSindustrie GM10, Руководство по эксплуатации

Страница: 30 / 80

29/07/2020 30
Material entry and operation
Attention must be paid to solid base for operating personnel!
Place the hacking items onto the base of the funnel and guide the thicker end (trunk) to the retraction roller
(taper off thick trunks at the end)
As soon as that have taken the material, step to one side because even as in the trunk can lead to flying
particles
.
The material is now automatically shredded and pushed in the direction (distance) previously adjusted for the
ejection channel.
After entering the material, you should occasionally check the ejection of the chopped wood and possibly
readjust the direction of ejection. The width of the ejection is controlled by the ejection flap (see page 20)
When hacking splinters, bark and branches, you can avoid the formation of splinters by guiding the material
into the retraction chute next to each other lengthways.
If no more retraction takes place (blockage due to excessive material or branch forks), press the switch lever
using "halt" into the "reverse" end position (rollers turn backwards) and the hacked items are pushed back.
Now shred the material quantity or saw off branch forks and start loading again.
If the drive power is currently too low (motor speed reduces heavily), briefly switch off the retraction (bring
switch bracket into the "halt" position) until a motor speed has reached the working speed again then set the
switch lever back to "forwards" (work) (the special equipment ABS system regulates this automatically).
Once work has ended, switch off the drive motor and lock the switch bracket. The funnel can only be cleaned
with suitable aids made of wood. Now the funnel extension is folded in and secured with the spring bar.
To finish, place the ejection to the back in the direction of travel and take off the parking supports.
Caution:
The wood shredder can only be operated with the retraction flat folded down!
Do not reach into the funnel when the machine is running! Push small pieces of wood through using a
wooden stick or pusher if necessary! Never push the hacked material through the funnel with a metal rod or
metal pusher! It is also forbidden to remain in the danger zone! With particularly strong or hard wood, it
makes sense, depending on the tractor power, to briefly set the drive motor to "halt" if the speed drops so
that the motor can achieve the nominal speed again.