Installation Procedure for Mounting Kits
Please follow these instructions when installing the UPS or Battery Extension
Units using mounting brackets MK-5000A, MK-5000B or MK-5000C. For
proper and safe installation, you will need a philips head screwdriver and two
people to assist you in holding the unit.
Installing the Brackets
(1) Inspecting the drawings, verify that you
have all the necessary brackets and bolts.
(2) Turn the UPS or Battery Extension Unit
upside down so that you are facing the
bottom of the unit.
(3) Place the left and right brackets so that
the holes in them line up with the mounting
holes on the bottom of the unit.
(4) Use the 4 screws
A
(size #8-32, length
3/8”, thread-forming) to fasten both brackets
firmly to the unit.
Cabinet Installation (for MK-
5000A & MK-5000B)
(1) Make sure that the 19” cabinet is
assembled properly with the equipment
mounting rails securely installed at the
intended location. This should be either in
the front or rear of the cabinet for MK-
5000A or in the center of the cabinet for the
MK-5000B.
(2) Place the clip nuts included with the
rack-mounting kit at the intended height of
the cabinet. The two clip nuts for each rail
should be placed 1-3/4” apart, and at the
same height on both rails.
(3) Your two assistants should now hold the
unit (at both ends), keeping it in position at
A
A
A
A
MK-5000B
Left Br
acket
MK-5000B
Right Br
acket
B
B
A
A
A
A
MK-5000A
Left Br
acket
MK-5000A
Right Br
acket
1-3/4"
(44mm)
B
B
MK-5000A
19" Cabinet Flush Mounting Kit
MK-5000B
19" Recessed Mounting Kit
Installation Procedures for Mounting Kits
13
© Copyright—2000 TSi Power Corporation. All rights reserved.
TSi Power’s ongoing product improvement process makes specifications subject to change.
Other company’s product names herein are for identification purposes only and may be trademarks of their respective companies.
