TIRE SIPING MACHINE
OPTIONS
- STE-M AUTOMATIC CYCLE FEED
AUTOFEED CONTROL BOX BASICS
- TROUBLESHOOTING
Reconnect power to the unit and turn “ON.”
Look for a green light indicating the power is ON.
See green arrow. (Fig. 3)
If the green light is not on recheck the breakers.
FYI:
The orange arrow points to where an orange light comes on
when the unit is in “JOG” mode. This should not be a factor but
that’s what the orange light is for. The dial changes the Jog
distance. This too is a pre-set and should not be a factor.
FIG. 3
FIG. 4
The photos below identify the PC board in the control box. (Fig. 4 & 5)
There are four adjustment wheels that are key to setting up the Siper Autofeed.
FIG. 5
POWER
PULSE/ SURGE
This procedure covers adjusting the first wheel, power and possibly the second wheel, pulse/surge.
Only change one of these at a time and ONLY one notch at a time.
See Fig. 5 and turn wheel clock wise one notch.
It may be necessary to adjust the power setting by as many as 3 notches. Once the gear motor begins operating it
may operate intermittently. Turn pulse adjustment wheel one notch counter clockwise. Fine tune this setting one
notch at a time.
When complete close and secure the control box cover.
Содержание STE-M
Страница 6: ......
