TSCHAN TORMAX VSG, Инструкция по установке и эксплуатации

Страница: 9 / 9

05/2004 TSCHAN
   
-TORMAX VSG - 9 -
7.2 Replacing the rubber element
Injury hazard!
Switch off the drive before commencing any work on the coupling!
Secure the drive against accidental activation and rotation!
•
To replace the rubber element the coupling must be completely removed.
•
Lay the coupling flat on the bearing flange (Figure 1, Item 4) and remove the hexagon
socket screws (Figure 1, Item 7).
•
Dismantle the coupling and clean all coupling components.
•
Examine the coupling components
for wear or damage.
•
When replacing the rubber element
(Figure 1, Item 2), we recommend
you also replace the friction disk
and bearing ring (Figure 1, Items 5
and 6).
•
Reassemble the coupling compo-
nents with the new rubber element.
•
Please observe the correct relative
positioning of the torsional limiting
device stops in the coupling flange
and the bearing flange.
•
Gradually and uniformly tighten the
hexagon socket screws (Figure 1,
Item 7) in the correct order, until
reaching the torque T
An
given in Table 3.
Table 3 Cheese head screw torques:
VSG 6 8 10 16 22
DIN 912 - 10.9 M8 M8 M12 M12 M12
T
An
(Nm) 36 36 125 125 125
8 Disposal
Disposal is in accordance with the specific regulations of the respective country in which the
equipment is used.
Bild / Fig. 2 Lage der Durchdrehsicherung