TScale SP Series, Техническое руководство

Страница: 8 / 22

SP Series Technical Manual
- 7 -
4. INSTALLATION
Unpacking
Carefully take the balance out of its package, make it sure its not damaged and
all accessories are included.

Remove the Indicator from the carton.

Remove the protective covering. Store the packaging and to use if you
need to transport the scale later.

Inspect the scale and terminal for damage.

Make sure all components are included
Accessories,
1. Balance
2. Adaptor
3. Pan
4. Product manual
Level Adjusting
Place the scale on a table.
Check the water mark. If, bubble is not centre
adjust the leveling feet until reach centre. Check
the level when you change the location.
Charging Battery

To charge the battery insert the adaptor pin to jack, jack is locating below
the scale. Adaptor simply plug into the mains power. The scale no needs
to be turned on.

The battery should be charged for 12 hours for full capacity.

Left side of the display there is an LED to indicate the status of battery
charging. When the scale is plugged into the mains power the internal
battery will be recharged. If the LED is green, the battery has a full charge.
If it is red, the battery is nearly discharged and if yellow, the battery is
being charged.

Do not use any other type of power adaptor than the one supplied with the
scale.

Verify that the AC power socket outlet is properly protected.
Note: Please charge the battery before using the scale for the first time