23
4.3 Printer Initialization
Printer initialization clears all downloaded files resident in the flash memory and
sets printer parameters to default values.
Please follow the steps below to initialize the printer:
1. Turn off the printer power.
2. Hold down the
PAUSE
and
FEED
buttons and turn on the printer power.
3. Do not release the buttons until the three LEDs flash in turn.
Parameter
Default setting
Speed
50.8 mm/sec(2 ips)(203DPI)
38.1 mm/sec(1.5 ips)(300DPI)
Density
8
Label width
4” (101.6 mm)
Label height
4” (101.6 mm)
Sensor type
Gap sensor
Gap setting
0.12” (3.0 mm)
Print direction
0
Reference point
0,0 (upper left corner)
Offset
0
Print mode
Tear Mode
Serial port settings
9600 bps, none parity, 8 data bits, 1
stop bit
Code page
850
Country code
001
Clear flash memory
Yes
Shift X
0
Shift Y
0
Gap sensor
sensitivity
8
LCD Language
ENGLISH
IP address
DHCP
Note:
Printing method (thermal transfer or thermal direct printing ) will be set
automatically at the activation of printer power.
Download files will be deleted after printer initialization.
Sensor calibration is required after printer initialization before printing
labels.
