29
5.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the FEED button then turn on the power switch.
3. Release the FEED button when the indicator becomes
and blinking.
(Any green will do during the 5 blinks).
The LEDs will be changed as following order:
(amber)
(5 blinks)
(5 blinks)
(5 blinks)
(solid green)
Printer configuration will be restored to defaults as below after initialization.
Parameter
Default setting
Speed
50.8 mm/sec (2 ips)
Density
8
Media Width
2.83
” (72 mm)
Media Height
4” (101.5 mm)
Sensor Type
Black mark sensor (As paper end sensor)
Black Mark Setting
As paper end sensor
Print Direction
0
Reference Point
0,0 (upper left corner)
Offset
0
Serial Port Settings
9600 bps, none parity, 8 data bits, 1 stop bit
Code Page
850
Country Code
001
Clear Flash Memory No
IP Address
DHCP
