Tryton TUW550, Руководство по эксплуатации, Страница: 6 / 32

TIPS REGARDING OPERATION:
ź
After a longer operation at low speeds run the power tool at its
maximum speed with no load for about 3 minutes to cool it down.
ź
To drill holes in ceramic tiles use a drill bits for glass and glaze.
ź
When drilling in metal use sharp metal drill bits only.
NOTE: Proper drill bit selection reduces vibrations during drilling, which
NOTE:
increases drilling efficiency considerably.
ź
When tightening/undoing screws place the bit onto the screw/nut
when the chuck is stopped.
STORAGE AND MAINTENANCE:
Generally, this power tool does not require any special maintenance.
Store the machine in a place away from children, keep it clean and
protect from humidity and dust. Storage conditions should exclude any
mechanical damage and weathering.
After drilling in intensely dusty environments it is recommended to
remove dust from ventilation openings and the drill chuck with a stream
of compressed air. It will protect bearings and remove the dust
obstructing motor cooling air supply.
TRANSPORTATION:
The drill should be transported and stored in a box providing protection
against humidity, dust and tiny objects penetration; special care should
be taken to protect ventilation inlets. Small objects that get into the
device can damage the motor.
TROUBLESHOOTING GUIDE (TYPICAL PROBLEMS):
The drill does not work:
- check whether the power cord ( 6 ) is properly connected and check
fuses.
The drill works with interruptions or generates sparks:
- check and replace carbon brushes.
NOTE! Carbon brushes can be replaced only by competent electricians.
- If the power tool does not work despite being supplied from a proper
power source, have the tool repaired sending it to the service center
. The
addresses are provided in the warranty card.
MANUFACTURER:
PROFIX Ltd.,
34 Marywilska Street,
03-228 Warsaw, POLAND.
PROTECTION OF THE ENVIRONMENT:
The symbol nearby denotes that old equipment must
never be thrown away together with other waste (with the
penalty of a fine).
Hazardous components of electronic
equipment may adversely affect the natural environment and
human health.
Each household may contribute to the recovery and reuse (recycling) of
old machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being created. The system
obliges all organizations that sell such equipment to collect the used
machinery and appliances. Moreover, general purpose collecting points
for such equipment are available.
PICTOGRAMS:
Explanation of the icons located on the nominal plate and the
information tags
.
6
«Always wear safety goggles»
«Wear » hearing protection
«Wear a dust mask»
«Read this instruction before switching on the
power supply and starting the work»
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device purchased.
This
instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.