Tryton TFV12, Руководство по эксплуатации

Страница: 7 / 52

STORAGE AND MAINTENANCE:
The tool in principle does not require any special maintenance or service.
The tool must be stored in a place that is not accessible to children and
must be kept clean and protected from moisture and dust. The storage
conditions should prevent potential mechanical damage and impact of
the weather conditions.
TRANSPORTATION:
CAUTION:
small
quantity of soap and then wiped dry. Do not use any detergents or
solvents as they can damage parts made from plastics.
Sp. z o.o.
NOTE:
old machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being created. The system
obliges all organizations that sell such equipment to collect the used
machinery and appliances. Moreover, general purpose collecting points
for such equipment are available.
PICTOGRAMS:
Remember to always disconnect the battery from the tool prior
Explanation of the icons located on the nominal plate and the
to starting the cleaning operations and unplug the charger from the outlet.
information tags :
The charger may be cleaned exclusively with use of a dry cloth.
Use also a clean cloth to clean regularly the ventilation openings of the
tool to keep them patent. From time to time disassemble the grip and
remove dust and other rubbish from the interior.
The tool housing must be cleaned with use of a moistened cloth
After cleaning let
the tool dry completely before it is used again.
Store and transport the tool in its transport box to protect it against
humidity, dust penetration and small objects; remember to protect its
ventilation openings. Small objects after getting into the casing can
MANUFACTURER:
result in damage to the motor.
PROFIX ;
PROTECTION OF THE ENVIRONMENT:
ul. Marywilska 34 ,
The symbol nearby denotes that old equipment must
03-228 Wars z aw a , POLAND.
never be thrown away together with other waste (with the
This appliance is in conformity with national and European standards as
penalty of a fine). Hazardous components of electronic
well as with general safety guidelines.
equipment may adversely affect the natural environment and
human health. Any repairs are allowed to be carried out exclusively by qualified staff
Each household may contribute to the recovery and reuse (recycling) of with use of original spare parts.
7
« » Always wear appropriate eye protection
« » Use appropriate hearing protection
«Read this instruction before switching on the
power supply and starting the work»
TROUBLESHOOTING GUIDE:
PROBLEM POSSIBLE CAUSE REMEDY
Irregularities of the motor
operation.
Worn carbon brushes of the motor. Have the brushes replaced at a service workshop.
The tool (drill/screwdriver)
fails to operate.
No power voltage, damaged
motor or the power trigger.
Check the battery status, recharge or replace with a new one when necessary.
When the problem persists hand over the tool for repair at a service workshop.
Please refer to the warranty sheet for addresses of authorized workshops.
Battery low. Recharge the battery.
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device purchased.
This instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.