Tryton TDS125B, Руководство по эксплуатации

Страница: 9 / 60

9
part does not heat up excessively, does not lose its color and no grooves
or other roughness will appear on its surface.
Store and transport the grinder in its transport box to protect it against
humidity, dust penetration and small objects; remember to protect its
NOTE: Never use cutting disks to grind/remove layers.
ventilation openings. Small objects after getting into the casing can
n
Cutting
result in damage to the motor.
While cutting with the tool do not exert excessive pressure, do not tilt
and do not oscillate. Move the tool at a constant speed adjusted to the
MANUFACTURER:
material machined.
PROFIX Ltd., 34 Marywilska Street, 03-228 Warsaw, POLAND
Do not brake the rotating disk by pressing it against other objects.
PROTECTION OF THE ENVIRONMENT:
NOTE: Observe proper cutting direction. Cutting should be carried out at
The symbol nearby denotes that old equipment must
the direction shown on the disk (see: Fig. I , p. 3 ). Do not cut in opposite
never be thrown away together with other waste (with the
direction! Otherwise the tool may be pulled out from the cutting line.
penalty of a fine). Hazardous components of electronic
equipment may adversely affect the natural environment and
The tool does not require any special maintenance. Store it away from
human health.
children, keep clean and protect against humidity and dust. Storage
Each household may contribute to the recovery and reuse (recycling) of
conditions should exclude any mechanical damage or harmful weather
old machinery and equipment. Both in Poland and Europe a system for
factors.
recovery of used equipment either exists or is being created. The system
This device meets the requirements of national and European standards
obliges all organizations that sell such equipment to collect the used
and safety guidelines. Any repair can be carried out only by qualified
machinery and appliances. Moreover, general purpose collecting points
personnel using original spare parts.
for such equipment are available.
n
Cleaning
PICTOGRAMS:
To provide safe and efficient operation, the grinder casing and ventilation
Explanation of the icons located on the nominal plate and the
openings should be free from dust deposits and other pollutants. We
information tags .
recommend that you clean the grinder directly after each use.
Wipe the grinder with a clean, slightly wet cloth with a small amount of
soap. Do not use any cleaning agents or solvents; they can damage parts
made of plastics. Protect the grinder's inner parts against water.
After using the tool in dusty atmosphere it is recommended to clean the
ventilation openings with compressed air to avoid damage to the
bearings and remove dust blocking the air used for cooling the motor.
- check whether the power cord ( 8 ) is correctly plugged in and the
electric power outlet is energized;
- check condition of carbon brushes and replace them if necessary.
- if the defect persists, the tool fails to work despite of voltage presence
and carbon brushes are in good condition, hand the tool over for repair
to an authorized workshop to the address specified in th
e warranty
card .
TRANSPORT:
STORAGE AND MAINTENANCE:
TROUBLESHOOTING:
The electric tool fails to switch on or works with breaks:
NOTE!
NOTE! Carbon brushes can be replaced only by competent electricians.
«Always wear safety goggles»
«Wear » hearing protection
«Wear protective gloves »
«Wear a dust mask»
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device
purchased.
This
instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.
«Read this instruction before switching on the
power supply and starting the work»