Trynex SweepEx SWB-480, Руководство по сборке

Страница: 3 / 16

3 © TrynEx International 2013 (REV A) F51302C
Introduction
These assembly instructions have been designed to guide you in assembling your SWB-480 Rotary Sweeper. Follow these instructions with
care to ensure performance and longevity.
Please read and understand the safety warnings associated with the assembly of the equipment before beginning. In addition the safety
information in the these instructions, observe general safety guidelines to maintain your safety and the safety of those around you.
To assemble the SWB-480 you will need a set of metric tools.
THIS SIGN SHOULD ALERT YOU:
This Safety Alert Symbol is used to pinpoint characteristics that, if not carefully followed, can create a safety
hazard. When you see this symbol in this manual or on the machine itself, be alert! Your personal safety and
the safety of others is involved.
Defined below are the Safety Alert Messages.
DANGER
Information that, if not carefully followed, can cause death.
WARNING
Information that, if not carefully followed, can cause serious personal injury or death.
CAUTION
Information that, if not carefully followed, can cause minor injury or damage to equipment.
IMPORTANT
This symbol is used to call out information that is important to follow carefully.
Note: Pictures in this publication may show the SWB-480 with optional accessories or brush kits.
Refer to the “Component Vocabulary” section of the Owner’s Manual to become acquainted with the names of parts.
In each step, hand-tighten all fasteners until the step is complete,
then tighten to the recommended torque. (The chart references thread
diameter, not wrench size.)
To prevent damage to the equipment, do not tighten fasteners with
plastic nuts or directly contacting plastic parts to the recommended
torque. Tighten until firm.
TORQUE CHART FT-LB
Fastener Recommended
Torque
M6 7.8
M8 20.25
M10 42.75
M12 72
M19 250
T20 7.75
RECOMMENDED FASTENER TORQUE