© TrynEx International 2013 (REV C) F50766
8
Installation Instructions
Connecting to the Spreader’s Control Module
Orange Wire
from Control Board
Red Wire
from F50679
Pump Harness
F50681
Prewet Battery Wire
Green Wire
from Control Board
STEP 10
Remove the Nut and Serrated Washer from the “GND -” Terminal. Place the Black Wire of the PWX Harness onto the “GND -” Terminal. Reinstall
the Nut and Washer. Tighten.
STEP 11
Reinstall the Spinner Harness. The White Wire belongs on the “S” Terminal; the Black Wire belongs on the “Spinner -” Terminal. Place Nut
and Washer on Stud. Tighten both nuts and the Cord Restraint.
7/16” Nutdriver... 15/16” Wrench... Adjustable Wrench...
STEP 12
Install the round Terminal End of the Relay Wire [F50681] onto the “BAT +” stud. Replace Nut and Washer. Tighten.
STEP 13
Wire the Relay [D6083] as shown. Use Dielectric Grease.
