© TrynEx International 2013 (REV C) F50766
12
Installation Instructions
Installing on the Spreader
STEP 8
Push hose through the hole (oval-shaped) in the Rear Auger Extension [where the pump will be mounted]. Install the Filter [D5267] onto the end of
this Hose. The Hose fits onto the Hose Barb coming off the end on the Filter. Clamp with the remaining 1/2” Plastic Hose Clamp [F50146].
STEP 9
Mount Pump [D5265] to the Rear Auger Extension. Use the Pump Mounting Hardware Kit. The Pump should be mounted so the head of the Pump
faces rearward. The Washers [D5292] and the Bolts [D5948] should be on the “Pump-Side” and the Nut [D5948] should be on the other side of the
metal. Tighten until the Rubber Pump Feet are slightly squished.
STEP 10
Connect the Filter to the Inlet of the Pump. This should be on the upward side. Secure the connection by pushing the Tab on the Pump until it clicks
into position.
