TRUST SPYC@M 300S
1 Introduction
This instruction manual is for the TRUST SPYC@M 300S. This camera can be used
to take photographs and record video clips. The camera can also be used as a
webcam for videoconferencing.
U K
2 Safety
2.1 General
information
Read the following instructions carefully before use.
-
The TRUST SPYC@M 300S does not require any special maintenance. Use a
slightly damp, soft cloth to clean the camera.
-
Do not use aggressive substances, such as benzene or white spirit, to clean
the device. These may harm the material.
-
Do not submerge the device in liquid. This may be dangerous and will damage
the device. Do not use this device near water.
-
Do not repair this device yourself.
2.2 Batteries
1.
The alkaline batteries supplied with the camera are not rechargeable. Do not
attempt to recharge these batteries. There is a danger of them exploding.
2.
Never throw the batteries onto an open fire. The batteries may explode.
3.
Never drill holes into the batteries.
4.
Keep the batteries out of the reach of small children.
5.
Only use AAA alkaline or rechargeable NiMH batteries with this camera.
6.
When the batteries are empty, ask your local authority where you can
dispose of them.
Note:
Standard NiCd batteries are not suitable for use with this camera.
Note:
When the batteries are low or empty, all the photographs you wish to keep
should first be downloaded onto your computer and saved before the
batteries are replaced. All the photographs will be deleted from the camera’s
memory when the batteries are replaced.
Note
: Do not use old and new batteries at the same time, because the old batteries
may deplete the new ones.
Note
: The batteries should be removed if the camera is not going to be used for
some time. This will save the battery capacity.
3 Approval
This device meets the essential requirements and other relevant conditions of the
applicable European directives. The Declaration of Conformity (DoC) is available at
www.trust.com/13947/ce.
4
Using the camera
4.1
Inserting the batteries
1.
Open the camera’s battery compartment as shown in Fig. 1.
2.
Insert the batteries into the camera as indicated in the battery compartment.
3.
Close the battery cover.
Note
:
Inserting the batteries incorrectly will cause damage.
1
