TRUST 913 POWERC@M ZOOM
Problem
Cause
Possible solution
The batteries may be nearly
flat.
If the batteries are too weak,
the flash will be unable to
recharge. Turn the camera
off and wait a few seconds
before turning it back on. If
this does not work replace
the batteries.
Hold the camera steady,
If necessary use a stand
The camera or subject was
moving when the shot was
taken.
Use the self-timer
The images are
blurry
Lens focus adjustment
Check that the focus is
correct (see page 37).
The computer does
not recognize the
camera
The camera was connected
to a personal computer by
USB before installing
software.
Connect the camera to the
computer with the USB cable.
Select [My computer] >
[Control panel] > [System] >
[Device manager].
From [other devices] delete
[Composite USB device] or
[unknown device].
Disconnect the camera from
the computer, install the
software, and then reconnect
the camera.
Cannot zoom in on
photo (in playback
mode)
Photo resolution is 6.6
Megapixel (2976x2232)
This is not possible in this
resolution. View the photo on
the computer.
Cannot read the
manual of Photo
Explorer 2.01 (mac)
Acrobat reader is not
Installed.
Install Acrobat Reader
(www.adobe.com)
Windows ME and
Windows 2000:
when the USB
cable is unplugged
from the PC, an
"Unsafe Removal
Device Detected"
error message
appears.
When removing USB
devices, it is recommended
that users follow the "Safe
Removal of USB Device"
procedure.
Procedure:
a. Right-click
the
Unplug
or
Eject hardware icon at
the bottom-right of your
computer screen.
b. Left-click the Unplug or
Eject hardware text box
to open the 'Unplug or
Eject Hardware' screen.
c. Select
the
device
from
this screen and click on
the Stop button to
confirm that the device is
to be stopped.
d. From the 'Stop a
Hardware device'
confirmation screen,
select the device to be
stopped and click OK to
bring up the 'Safe To
18
