Trust 71017-02, Руководство пользователя

Страница: 9 / 36

ASUN-650 SUN BLINDS SWITCH
1
1. Switch off the mains power (electric meter box)
before installing this product
2. Remove the existing switch
Detach the existing switch and disconnect the wires.
The existing wall switch is replaced by this product and can
no longer be used. Consult the supplier of your sun blind
system when in doubt about motor type and wire colors.
3. Connect 230V power supply
Connect the (brown) live wire to the [L] contact.
Connect the (blue) neutral wire to the [N] contact.
Contact an electrician when in doubt about wire colors.
Tighten the clamping screws.
4. Connect motor wiring
How to connect the motor wiring depends on
the type of motor:
• Read step 5 for a 230V motor.
• Read step 6 for a 12-24V motor.
• Read step 7 for a motor with a momentary switch.
5. Connect 230V motor
1. Connect the (blue) neutral wire from the motor to
the [N] contact.
2. Use a seperate piece of wire to connect [L] with [COM].
3. Connect the live wires from the motor (brown and black)
to the [
] and [ ] contact. These positions can
be interchanged to reverse the up and down motion of
the motor.
6. Connect 12-24V motor
1. Connect the 24V+ wire to [COM].
2. Connect switch wires A and B to the [
] and [ ]
contact. These positions can be interchanged
to reverse the up and down motion of the motor.
Never connect 230VAC wires to low-voltage wires.
7. Motor with momentary switch
The motor only has 2 wires.
1. Connect one wire to [
] and the other wire to [COM].
These positions can be interchanged to reverse the up
and down motion of the motor.
2. Use a seperate piece of wire to connect both
[
] and [ ] contacts. Never connect 230VAC wires to
low-voltage wires.
8. Switch on the mains power (electric meter box)
to continue the installation
Shock hazard! Do not contact any exposed wiring.
Only touch the plastic housing of this product.
9. Activate learn-mode
Press the learn-button on the receiver for 1 second.
The learn-mode will be active for 12 seconds and the
LED-indicator will blink slowly.
10. Assign Trust Smart Home transmitter code
While the learn-mode is active, send an ON-signal with any
Trust Smart Home transmitter to assign the code to the
receiver’s memory.
EN