Truper ROTI-12AC, Руководство пользователя

Страница: 19 / 24

Chuck
base
Jaws
Forward Reverse
7
Start Up
The battery is shipped DISCHARGED from the factory. It will be necessary to charge the battery 1 hour approximately before
being able to use it.
The regular charging temperature is from 32 °F to 113 °F. Out of this range, charging stops immediately until reaching the right
temperature. The normal discharge / work temperature is 32 °F, and up to 167 °F. If exceeding 167 °F the electronic control will
stop the tool power until the temperature gets the optimal temperature range. When the battery shows a low power level while
working, the tool stops running.
Give the charger a 15-minutes’ rest between charges. In hot environment or after long use, it is possible that the battery gets
too hot to be recharged. Give the battery cooling down time before trying to recharge it.
General remarks for using the battery
Torque
Regulator
• Using one hand, hold firmly the handle and with your
other hand loosen the base turning in a counterclockwise
direction, to loosen the jaws.
• Insert the bit all the way in or remove it as needed.
• Turn the base clockwise to fasten the bit.
Installation of Bits or Adapters
• To drill or screw, release the switch and press the rotation direction button
where the arrows point towards the chuck.
• To reverse the direction and screw out, press in the opposite side.
• The switch gets blocked if the button is in the middle position.
The first time you switch on the drill and after reversing
the rotation direction, you may hear a “click”. This is normal and does not
represent a problem.
Never reverse the rotation direction while the drill is
running. The tool may be damaged.
Rotation Direction
• The two speeds set in the hammer-drill work similar to the gears
in a car.
• Low speed (
1
) will give a lot of torque (torsion power). Use this
speed when starting to drill big orifices, on both metal or wood.
This will prevent the drill from getting stuck.
• The high speed ( 2 ) has a reduced torque but lets the drill to run
higher revolutions per minute. This makes the drill to cut faster
wood or thin metal.
Speed Selection
CAUTION
CAUTION
ENGLISH
• To bore concrete, tiled floor or materials similarly hard, turn the torque
regulator into the IMPACT ( ) position. The bit will strike and rotate
at the same time onto the material.
• To bore metal or plastic turn the impact-rotation selector chuck into the
DRILL ( matching with the top mark) position to make the bit rotate
against the material.
• Do not try to drill metal, wood or plastic with the
hammer drill in the IMPACT mode. Otherwise the tool efficiency would
diminish and the bit tip will get damaged.
Change from hammer drill to drill
WARNING