Truper ROEL-50N2, Руководство пользователя

Страница: 20 / 24

8
Start Up
•SDS accessories need freedom of movement inside the chuck. This
causes eccentricity when the tool is unloaded. However, the
accessory gets centered automatically during the operation with no
affectation the drilling precision.
• When the tool is new it requires 5 hours working to gain its
maximum efficiency.
• When using the tool in the drill or hammer drill mode first, set the
bit tip in the point where the orifice will be bored and then press the
switch.
The tool is built with an overload breaker that
stops the axis force (causing a rattling sound)
if the accessory gets stuck. If this happens:
• Turn off the tool immediately.
• Remove the stuck accessory.
• Turn On the tool.
Additional Information Overload Brake
Drill with no impact
WARNING
Use of the Dust Guard
• Slide the dust guard over the bit before boring vertically
over the head. The dust guard will prevent dust from
falling over the tool and the operator when drilling
ENGLISH
Metal, wood or plastic can be drilled with
the tool using drill / accessory bit three
jaws chuck with an SDS adapter (NOT INCLUDED).
• To install the three jaws chuck, go as with any other SDS accessory
(page 7, drill / accessory Installation).
• Set the bit into the three jaws chuck until is stops and secure with
the chuck key tightening each one of the orifices alternatively.
Never use the three jaws chuck with the selector
in the operation mode in the IMPACT positions ( , , ).