Truper 19589 Скачать руководство пользователя страница 16

            BOOST MODE

NOTE: 

The unit will change automatically to the          

boost

 

mode, depending on the voltage. To select the         

charge / 

maintenance

 mode, press the         

charge selection

 button.

To select the boost mode, press the           

charge selection

 

button until the LED light is yellow / orange to          boost to  

40 A is lit

The light          

LED

 will light up if the battery is connected 

correctly and the boost process will start.

NOTE:

 The boost mode will remain energized until pulsing the 

         

charge selection

 button or until the ON / OFF main switch 

is in the OFF position

            CHARGE / MAINTENANCE MODE

To select this mode, press the          

charge selection

 button 

until the yellow / orange 6 <> 2 A LED light for        

charge / 

maintenance

 is ON.

The         

LED

 light will illuminate if the battery is correctly 

connected; then, the charging process will start.

When the battery is completely charged, the green LED light for    

         

charging / maintenance

 will illuminate. If the charge 

cannot be completed, the LED

 light reversed clamps / defective

 

battery

        

 

(RED) will illuminate. The battery may be in bad 

repair. Check it.

NOTE:

 If the battery voltage is lower than 12,7 V    , the charger 

will automatically enter the boost mode to add in a fast manner, 

energy to the battery. To abort / avoid temporary increase and 

force the charger in the          

charge selection

 mode, press the 

charge selection button again (while boost continues).

            USING THE START MOTOR FUNCTION

 

The battery charger can be used to boost the automobile if the 

battery is low. Follow all instructions and safety caution 

measures in charging the battery.

Wear full eye protection and protective clothes.

Using the motor start function in the motor 

when the battery is not installed in the vehicle will damage the 

electric system.

NOTE

:In extreme cold weather or if the battery is smaller than  

2 V, boost the battery during 5 minutes before starting the 

motor.

NOTE:

 If you have already charged the battery and the vehicle 

still is not starting, do not use the motor start fuction. It will 

damage the electric system in the vehicle. Have the battery 

checked.

1.   

Set the selector into the OFF position. 

2.  

Unplug the charger from the alternate current power supply.  

Connect the charger to the battery following the instructions 
in “charging the battery in the vehicle” section

3.  

Connect the charger alternate current power cable to the 

alternate current power supply.

4.  

Having the charger connected to the vehicle battery, adjust 

the ON / OFF switch into the           

motor start

 position.

 

5.  

Start the motor until it starts running or after 5 seconds. If 

the motor is not starting, wait a few minutes before trying 
again. This will cool down the charger and battery.

NOTE: 

After 3 minutes in the start motor mode, the charger will 

enter a 180 seconds cooling period.  The yellow / orange LED of                             
   

motor start

 will blink during the cooling period.

6.  

If the motor is not starting, use the adjust 40 A           

boost

 

during 5 minutes before starting again. 

7.  

After the motor is running, turn the selector into the OFF 

position and disconnect the power cable from the alternate 
power supply before disconnecting the clamps from the 
vehicle battery. 

8.  

Clean and store the charger in a dry place. 

NOTE: 

If the motor rotates but is not ON, there is no problem 

with the starting system, but in any other part of the vehicle.  
STOP starting the motor until the problem is diagnosed and 
corrected. 

CHARGING TIMES

These times are based in a battery 50% discharged and may 
change depending of the age and condition of the battery.

OVERRIDE CHARGE

If the charge cannot be completed normally, the charge will 
override. When the charge is interrupted, the charger output is 

OFF and the 

LED inverted clamps

       

 

 (RED) will illuminate. Do 

not continue trying to charge this battery. Check the battery 
and replace if necessary

DESULPHURIZATION MODE

Desulphurization can take 8 to 10 hours. If desulphurization fails, 

the charge will be aborted and the 

LED inverted clamp       

(RED) 

will illuminate.

APPLICATION

Powersports

6 Ah

32 Ah

6

15

Automotive

Marine

CHARGING TIME (HOURS)

2 A    6 A    8 A    10 A

BATTERY

SIZE

300 CCA

1 000 CCA

50 Ah

105 Ah

2

5

1,75

4,5

1,5

4

12

30

4

10

3,5

8,5

3

7

15

33

5

11

4,25

9,5

3,5

8

WARNING

6

Содержание 19589





















Отзывы: