Truper 17247, Руководство пользователя

Страница: 20 / 24

8
Maintenance
Troubleshooting
C
D
• Always keep the ventilation slots clean and free of
obstructions to guarantee the proper cooling of the motor.
• Inspect regularly all the mounting nuts and double check
for proper tightness. In case there are lose nuts, tighten
immediately.
• Service to the tool shall only be carried out in a
Authorized Service Center. Service
and maintenance carried out by non-certified people may
result dangerous o cause personal injuries and voids he
product warranty.
Cleansing and Care
• Drain the water trap: have the compressor running. Raise
the drain valve ( C ) in the bottom of the water trap. This way,
humidity condensed inside the compressor is eliminated.
After Each Use
• Clean the carrier filter element (
D
) using compressed air.
Every Three Months
Service
The motor is not
running.
The motor starts but
makes irregular or
clacking noises.
There is not enough
pressure when
painting or spraying.
The motor is running
correctly but there is
no air pressure or air
supply failure.
• There is no power
supply.
• The power cord is
damaged.
• The electric wiring
inside the unit is
defective.
• The switch is defective.
• A bearing is loose or
damaged.
• Loose screws in the
rod.
• Loose air
connection(s).
• The air hose is
damaged.
• The screws in the
cylinder cover are loose.
• The valve plate is out
of place.
• The retention ring is
damaged after excessive
use of high pressure.
• Connect the power cord into a grounded 110 V power outlet.
• Take the tool to a Authorized Service Center.
• Take the tool to a Authorized Service Center.
• Take the tool to a Authorized Service Center.
• Take the tool to a Authorized Service Center.
• Take the tool to a Authorized Service Center.
• Check all air connections and tighten as necessary.
• Replace the air hose.
• Tighten the screws.
• Take the tool to a Authorized Service Center.
• Take the tool to a Authorized Service Center.
Problem Cause Solution
ENGLISH