Truper 15420, Руководство пользователя

Страница: 19 / 24

7
Start Up
Start Up and Operation Control
• Intermittent Operation:
Connect the plug into the outlet.
Press switch ( A ) to start the Jigsaw.
To stop the tool, simply release the switch.
• Continuous Operation:
Connect the plug into the outlet.
Press the switch ( A ) and block it pressing the continuous use button ( B ).
To stop the tool, press and release the switch.
Adjusting the Cutting Angle
• Disconnect the unit from the power source.
• Loosen the 2 screws on the base plate with the
Allen key included.
• When the screws are loosened, adjust the base
plate into the desired angle using the serrated
guide in the base plate.
• Tighten the screws back.
• Set the Allen key back in its holder in the power
cable protector immediately after use.
Particle Vacuuming
Connect the dust collector to the Jigsaw through the vacuum
cleaner vacuum cleaner connection to collect the dust.
Vacuum clean dust, sawdust or any particle from the work
surface.
Dust
Collector
Swinging action varies the blade cutting angle to increase the
cutting efficiency.
It shall be adjusted with the Jigsaw unloaded. Do not apply
excessive force on the blade when cutting with the swinging
action. The blade cuts only upwards.
Swinging Action Control
Thin materials. Fine
Cuts, Sharp Corners
(steel and wood).
Thick materials (steel
and chipboard)
Thick material (wood)
Swinging
Action Control
ENGLISH
A
B
Speed
control
Speed control Speed guide
• The tool can operate at different speeds. You can select the speed
by adjusting the speed control into the tool upper side.
• Adjust speed with the speed control according to the material, its
width and the blade specification (it is possible to do this when
running without load). See the speed guide to select the right speed
for the job.
• Avoid running at low speed for long periods. The
motor might be damaged.
Material Speed
Rubber
Aluminum
Steel
Wood
1-2
3-4
4-5
5
WARNING
Fast cuts (soft wood)
Cutting along the
wood grain.