9
Start Up
E
I
H
G
1
G
2
F
Switch ON
Before starting the gas pressure washer
please pay attention to the following. Failure to comply
with this note could damage the machine and make the
warranty void:
• All the hoses shall be connected, completely untangled
and not presenting kinks.
• Water supply shall be connected and fully open.
• Gasoline and oil levels shall be the correct ones.
• The system shall be purged out of air bubbles.
(see page 7).
• Open the fuel valve (
E
).
• Switch it on (
F
).
• Move the choke lever to the “START” position (
G
1
).
• Move the throttle lever (I) to the left, to the high-speed
position.
• Pull the jack-line (
H
) until the motor starts but no more
than 6 times. Whenever pulling the jack-line release it
gently into its original position. Do not allow it to snap
back.
• After the motor runs a couple of seconds. Then move
the choker lever into the “RUNNING” position (
G
2
).
• In case the motor is not starting after
pulling out the jack-line, tighten the high-pressure gun trigger
to release water pressure before trying to star the motor again.
CAUTION
Switch OFF
• Release the gun trigger to stop the pressure jet.
• Move the accelerator lever (
I
) to the right into the low
speed position.
• Switch off the switch.
• Close the fuel valve.
• Close the garden hose faucet.
• Press the high-pressure gun trigger to release pressure.
CAUTION
ENGLISH
