• Pull the belt tension lever until it stops.
• Choose the abrasive belt with the required grain and set
it straight and centered around the rollers. Double check
the arrow in the belt inner side points onto the same
direction that the sander in the belt sander.
• Push the lever to set it into its initial position.
• Turn on the sander to make the belt run. While
the tool is running but not making contact with any
surface turn the aligning knob until the belt runs
continuously in a straight way.
The belt shall be adjusted tightly to the
sander base. It shall not be loose.
CAUTION
Start up
Dust collecting
bag
6
Belt set up
• Intermittent operation: Connect the plug to the power
outlet. Press switch (
A
) to start the belt sander. To interrupt
using just release the switch.
• Continuous Operation: Connect the plug to the power
outlet. Press switch (
A
) and block it by pushing the
continuous use button (
B
). To stop, press and then release
the switch.
Turn On and operation control
• To prevent dust from accumulating in the belt
sander and the work place use the dust extraction
duct altogether with the collecting pouch or a
vacuum system if needed.
• Remove the dust bag when it is half empty and
pull out the fastener (
C
). Pour out the dust and pat
the bag to remove the dust sticked on the inner
bag, or it will influence the following dust
collecting.
Dust collection
C
ENGLISH
4
3
1
2
A
B
