14
Maintenance
E582EN_02.DOC
4. Check the drilling depth:
¾
If all cutting edges of the two blades are blunt: Insert new
blades.
or
¾
If only one of the cutting edges is blunt: Swap the blades
(oscillating lever and abrasive cutting head).
5. Place the blade closest to the oscillating lever onto the
cylindrical pin.
6. Place the blade closest to the abrasive cutting head onto the
cylindrical pin.
7. Tighten the fixing screws.
5.2 Replacing carbon brushes
The motor comes to a standstill when the carbon brushes are worn
out.
¾
Have the carbon brushes checked and replaced as required by
a qualified specialist.
Note
Only use original replacement parts and observe the information
on the rating plate.
