Trumpf TruSystem 7000, Руководство по обслуживанию

Страница: 267 / 306

Calibrate longitudinal travel motor
Service Manual TruSystem 7000 Operating Table – 1 764 986 – 10/2016
267
24.5 Calibrate longitudinal travel motor
The motor level position is set using the CAN test center. Follow the
software description from the CAN test center.
1. Establish a communication connection to the CAN test center
(PC).
2. Remove the energy chain (chain connection) from the center
box (2 screws) so that the marking on the bar is visible.
3. Move the table top at a slow speed until the end stop [1] on
the center box is centered between the markings [2] on the
bar.
4. On the "Target value" task card, press the "Set values" button
for "Position offset".
5. Reset (restart) the drive.
6. Check the end positions of the table top.
7. Close the connection to the operating table.
8. Attach the energy chain (chain connection) to the center box
(2 screws).
24.6 Calibrate tilt / Trendelenburg motor
The motor level position is set using the CAN test center. Follow the
software description from the CAN test center.
1. Establish a communication connection to the CAN test center
(PC).
2. Open the bellows and secure from above so that the spindle
of the drive is accessible.
3. Place the gauge #1525774 [1] on the socket [2] of the
spindle, and slowly move the motor downward until the
bearing plate [3] is at the upper end of the gauge. If needed,
raise the motor upward a bit so that the gauge can be inserted.
Important: do not travel to the mechanical end stop.
4. On the "Target value" task card, press the "Set values" button
for "Position offset".
5. Reset (restart) the drive.
6. Check the end positions of the table top.
7. Close the connection to the operating table.
8. Close the bellows.