TrueHVLP Apollo 7500 AtomiZer, Инструкция по эксплуатации

Страница: 26 / 35

4.9.2 Thorough Cleaning
Follow steps above for partial cleaning.
To further disassemble the spray gun now that you have already removed the air cap ring (#1), air cap (#2), fluid
nozzle (#3) and needle (#21), locate the air cap seal (#4). To remove the air cap seal, lay the spray gun on its side.
1. Locate the small groove on the air cap seal. You can rotate the groove to a
comfortable position for removal. (3 o’clock or 9 o’clock).
2. Place the flat tip of the wrench (spanner) in the air cap seal groove. Push in and pry up until the air cap seal
pops out. (Clean if necessary).
3. Remove the air distributor (#6) and clean if necessary.
3.
Remove the fan adjustment ring (#8) and air distributor plate (#7). The air distributor plate is attached to the
ring. These two pieces separate. Clean them both if necessary.