5
TRUE
TAC-27K / TAC-27K-HC-LD: AIR CURTAIN
www
.
truemfg
.
com
5
6
Images 4-6, removing skid from bottom of cabinet.
2
1
4
3
LOCATING
WARNING: BE SURE THERE IS ADEQUATE
VENTILATION IN YOUR ROOM. MAXIMUM AMBIENT
CONDITION 75 DEGREES AND 55% RELATIVE
HUMIDITY. WARRANTY IS VOID IF VENTILATION IS
INSUFFICIENT.
CLEARANCES
For proper cabinet operation, clearance guidelines should be
followed.
AIR CURTAINS
– 4" at the rear and 12" at the top.
A. Remove louver from the front of cabinet and backguard (if
applicable) from rear of cabinet. Remove louver grill by backing
out Phillips screws located on either side of the louver grill. See
image 1. Pull the louver grill out from the cabinet front. See
image 2. To reinstall grill, place louver grill back into brackets
located at the base of the unit. See image 3. Snap top of louver
grill into place. Replace screws).
B. Skid bolts are located in each of 4 corners inside cabinet
bottom. See image 4.
C. Remove skid bolts. See image 5.
D. Cut straps if applicable. See image 6.
E. Carefully lift cabinet off of skid.
LEVELING
A. Set unit in its final location. Be sure there is adequate ventilation
in your room. Under extreme heat conditions, (100°F+,
38°C+), you may want to install an exhaust fan.
WARNING: WARRANTY IS VOID IF VENTILATION IS
INSUFFICIENT.
B. Proper leveling of your TRUE cooler is critical to operating
success (for non-mobile models). Effective condensate removal
and door operation will be effected by leveling.
C. The cooler should be leveled front to back and side to side with
a level.
D. Ensure that the drain hose or hoses are positioned in the pan.
E. Free plug and cord from inside the lower rear of the cooler (do
not plug in).
F. The unit should be placed close enough to the electrical supply
so that extension cords are never used.
NOTE:
If the cabinet has a center leveling screw, castor, or leg,
make sure it is adjusted properly so it makes full contact with the
floor after the cabinet has been leveled.
WARNING: CABINET WARRANTIES ARE VOID IF
OEM POWER CORD IS TAMPERED WITH. TRUE
WILL NOT WARRANTY ANY UNITS THAT ARE
CONNECTED TO AN EXTENSION CORD.
INSTALLATION OF LEGS AND CASTORS
LEG LEVELERS:
If the cabinet is not level use an open-end wrench and turn adjustable
tips on legs until cooler is level. (See image 1).
CAUTION
To avoid damage to lower rail assembly, slowly raise unit to upright
position after installing castors.
Leg levelers in the bottom of the cabinet can be backed out for leveling.
1
