Truefitness.com / 800.426.6570 / 636.272.7100
17
CHAPTER 2: ASSEMBLY INSTRUCTIONS
ASSEMBLY STEPS (continued):
Step 10 Front Mast Cable Connections:
Step 11 Front Mast Assembly:
•
Install the front mast onto the bike frame; the short
bracket on the bike frame should fit inside the front
mast tube
•
Verify that the front mast is in the correct orientation;
the storage dock compartments and front mast
handlebars should be facing the seat assembly
•
For each hex screw (X11, quantity 5), install through
quantity 1 split washer (S11), followed by quantity 1
flat washer (F11)
•
Secure the front mast to the bike frame by tightening
all 5 screws with the provided 6mm hex wrench
•
Verify that the front mast is secured tightly to the bike
frame; tighten screws if necessary
•
Pull the storage dock down vertically so it covers the
bottom of the front mast assembly; the cup holder
should fit inside a mating hole on the plastic shrouds
•
At least 1 person should hold the front mast while
an additional person(s) routes the front mast cables
•
Route the bundle of cables through the front mast,
as shown in the provided image (left)
•
A pull-tie has been provided (attached to the front
mast tube) in order to help facilitate this routing