7. Locate the Brake Pedal Position (BPP) Switch under the driver side dash.
Connect the white wire from the 10RStager to the Green/Red wire on Pin 1 of the BPP Switch. This
should be a Y or T configuration so that signals are not interrupted. Reference the image below to
ensure assist with referencing the wires. Ensure that the wire maintains connection with Pin 1 as well
as the PCM/BCM connection. Next, connect the Pink wire to Violet/White wire on Pin 4 of the BPP
Switch as shown below. This should be a Y or T configuration so that signals are not interrupted.
BPP Switch Interface Wiring Diagram
8. On the 10RStager wire harness, connect the Red power wire to a switched 12V power source so that it
will only turn ON when Ignition Power is applied or when a dedicated switch is used. The 10RStager
consumes less than 0.5 Amps of current while under maximum load. Connect the Black wire to a clean
battery ground connection, as a poor chassis ground connection could damage the electronics or result
in inadequate performance. The Tranbrake enable (Lt Blue) and Stage enable (Violet) buttons should
be wired so that the 10RStager will see a high voltage when the buttons are depressed. Any 2-step
interfaces should be connected to the Light Blue wire connection or the Pink Brake Pedal interface
wire.
Refer to the Operators Manual on the following page for adjusting settings and tune modification
requirements.
Page 8
